| 1 | /* SPDX-License-Identifier: GPL-2.0 */ | 
|---|
| 2 | /* | 
|---|
| 3 | * xHCI host controller driver | 
|---|
| 4 | * | 
|---|
| 5 | * Copyright (C) 2008 Intel Corp. | 
|---|
| 6 | * | 
|---|
| 7 | * Author: Sarah Sharp | 
|---|
| 8 | * Some code borrowed from the Linux EHCI driver. | 
|---|
| 9 | */ | 
|---|
| 10 |  | 
|---|
| 11 | /* HC should halt within 16 ms, but use 32 ms as some hosts take longer */ | 
|---|
| 12 | #define XHCI_MAX_HALT_USEC	(32 * 1000) | 
|---|
| 13 | /* HC not running - set to 1 when run/stop bit is cleared. */ | 
|---|
| 14 | #define XHCI_STS_HALT		(1<<0) | 
|---|
| 15 |  | 
|---|
| 16 | /* HCCPARAMS offset from PCI base address */ | 
|---|
| 17 | #define XHCI_HCC_PARAMS_OFFSET	0x10 | 
|---|
| 18 | /* HCCPARAMS contains the first extended capability pointer */ | 
|---|
| 19 | #define XHCI_HCC_EXT_CAPS(p)	(((p)>>16)&0xffff) | 
|---|
| 20 |  | 
|---|
| 21 | /* Command and Status registers offset from the Operational Registers address */ | 
|---|
| 22 | #define XHCI_CMD_OFFSET		0x00 | 
|---|
| 23 | #define XHCI_STS_OFFSET		0x04 | 
|---|
| 24 |  | 
|---|
| 25 | #define XHCI_MAX_EXT_CAPS		50 | 
|---|
| 26 |  | 
|---|
| 27 | /* Capability Register */ | 
|---|
| 28 | /* bits 7:0 - how long is the Capabilities register */ | 
|---|
| 29 | #define XHCI_HC_LENGTH(p)	(((p)>>00)&0x00ff) | 
|---|
| 30 |  | 
|---|
| 31 | /* Extended capability register fields */ | 
|---|
| 32 | #define XHCI_EXT_CAPS_ID(p)	(((p)>>0)&0xff) | 
|---|
| 33 | #define XHCI_EXT_CAPS_NEXT(p)	(((p)>>8)&0xff) | 
|---|
| 34 | #define	XHCI_EXT_CAPS_VAL(p)	((p)>>16) | 
|---|
| 35 | /* Extended capability IDs - ID 0 reserved */ | 
|---|
| 36 | #define XHCI_EXT_CAPS_LEGACY	1 | 
|---|
| 37 | #define XHCI_EXT_CAPS_PROTOCOL	2 | 
|---|
| 38 | #define XHCI_EXT_CAPS_PM	3 | 
|---|
| 39 | #define XHCI_EXT_CAPS_VIRT	4 | 
|---|
| 40 | #define XHCI_EXT_CAPS_ROUTE	5 | 
|---|
| 41 | /* IDs 6-9 reserved */ | 
|---|
| 42 | #define XHCI_EXT_CAPS_DEBUG	10 | 
|---|
| 43 | /* Vendor caps */ | 
|---|
| 44 | #define XHCI_EXT_CAPS_VENDOR_INTEL	192 | 
|---|
| 45 | #define XHCI_EXT_CAPS_INTEL_SPR_SHADOW	206 | 
|---|
| 46 | /* USB Legacy Support Capability - section 7.1.1 */ | 
|---|
| 47 | #define XHCI_HC_BIOS_OWNED	(1 << 16) | 
|---|
| 48 | #define XHCI_HC_OS_OWNED	(1 << 24) | 
|---|
| 49 |  | 
|---|
| 50 | /* USB Legacy Support Capability - section 7.1.1 */ | 
|---|
| 51 | /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ | 
|---|
| 52 | #define XHCI_LEGACY_SUPPORT_OFFSET	(0x00) | 
|---|
| 53 |  | 
|---|
| 54 | /* USB Legacy Support Control and Status Register  - section 7.1.2 */ | 
|---|
| 55 | /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ | 
|---|
| 56 | #define XHCI_LEGACY_CONTROL_OFFSET	(0x04) | 
|---|
| 57 | /* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */ | 
|---|
| 58 | #define	XHCI_LEGACY_DISABLE_SMI		((0x7 << 1) + (0xff << 5) + (0x7 << 17)) | 
|---|
| 59 | #define XHCI_LEGACY_SMI_EVENTS		(0x7 << 29) | 
|---|
| 60 |  | 
|---|
| 61 | /* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */ | 
|---|
| 62 | #define XHCI_L1C               (1 << 16) | 
|---|
| 63 |  | 
|---|
| 64 | /* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */ | 
|---|
| 65 | #define XHCI_HLC               (1 << 19) | 
|---|
| 66 | #define XHCI_BLC               (1 << 20) | 
|---|
| 67 |  | 
|---|
| 68 | /* Intel SPR shadow capability */ | 
|---|
| 69 | #define XHCI_INTEL_SPR_ESS_PORT_OFFSET  0x8ac4	/* SuperSpeed port control */ | 
|---|
| 70 | #define XHCI_INTEL_SPR_TUNEN	BIT(4)		/* Tunnel mode enabled */ | 
|---|
| 71 |  | 
|---|
| 72 | /* command register values to disable interrupts and halt the HC */ | 
|---|
| 73 | /* start/stop HC execution - do not write unless HC is halted*/ | 
|---|
| 74 | #define XHCI_CMD_RUN		(1 << 0) | 
|---|
| 75 | /* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */ | 
|---|
| 76 | #define XHCI_CMD_EIE		(1 << 2) | 
|---|
| 77 | /* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */ | 
|---|
| 78 | #define XHCI_CMD_HSEIE		(1 << 3) | 
|---|
| 79 | /* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */ | 
|---|
| 80 | #define XHCI_CMD_EWE		(1 << 10) | 
|---|
| 81 |  | 
|---|
| 82 | #define XHCI_IRQS		(XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE) | 
|---|
| 83 |  | 
|---|
| 84 | /* true: Controller Not Ready to accept doorbell or op reg writes after reset */ | 
|---|
| 85 | #define XHCI_STS_CNR		(1 << 11) | 
|---|
| 86 |  | 
|---|
| 87 | /** | 
|---|
| 88 | * struct xhci_protocol_caps | 
|---|
| 89 | * @revision:		major revision, minor revision, capability ID, | 
|---|
| 90 | *			and next capability pointer. | 
|---|
| 91 | * @name_string:	Four ASCII characters to say which spec this xHC | 
|---|
| 92 | *			follows, typically "USB ". | 
|---|
| 93 | * @port_info:		Port offset, count, and protocol-defined information. | 
|---|
| 94 | */ | 
|---|
| 95 | struct xhci_protocol_caps { | 
|---|
| 96 | u32	revision; | 
|---|
| 97 | u32	name_string; | 
|---|
| 98 | u32	port_info; | 
|---|
| 99 | }; | 
|---|
| 100 |  | 
|---|
| 101 | #define	XHCI_EXT_PORT_MAJOR(x)	(((x) >> 24) & 0xff) | 
|---|
| 102 | #define	XHCI_EXT_PORT_MINOR(x)	(((x) >> 16) & 0xff) | 
|---|
| 103 | #define	XHCI_EXT_PORT_PSIC(x)	(((x) >> 28) & 0x0f) | 
|---|
| 104 | #define	XHCI_EXT_PORT_OFF(x)	((x) & 0xff) | 
|---|
| 105 | #define	XHCI_EXT_PORT_COUNT(x)	(((x) >> 8) & 0xff) | 
|---|
| 106 |  | 
|---|
| 107 | #define	XHCI_EXT_PORT_PSIV(x)	(((x) >> 0) & 0x0f) | 
|---|
| 108 | #define	XHCI_EXT_PORT_PSIE(x)	(((x) >> 4) & 0x03) | 
|---|
| 109 | #define	XHCI_EXT_PORT_PLT(x)	(((x) >> 6) & 0x03) | 
|---|
| 110 | #define	XHCI_EXT_PORT_PFD(x)	(((x) >> 8) & 0x01) | 
|---|
| 111 | #define	XHCI_EXT_PORT_LP(x)	(((x) >> 14) & 0x03) | 
|---|
| 112 | #define	XHCI_EXT_PORT_PSIM(x)	(((x) >> 16) & 0xffff) | 
|---|
| 113 |  | 
|---|
| 114 | #include <linux/io.h> | 
|---|
| 115 |  | 
|---|
| 116 | /** | 
|---|
| 117 | * Find the offset of the extended capabilities with capability ID id. | 
|---|
| 118 | * | 
|---|
| 119 | * @base	PCI MMIO registers base address. | 
|---|
| 120 | * @start	address at which to start looking, (0 or HCC_PARAMS to start at | 
|---|
| 121 | *		beginning of list) | 
|---|
| 122 | * @id		Extended capability ID to search for, or 0 for the next | 
|---|
| 123 | *		capability | 
|---|
| 124 | * | 
|---|
| 125 | * Returns the offset of the next matching extended capability structure. | 
|---|
| 126 | * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL, | 
|---|
| 127 | * and this provides a way to find them all. | 
|---|
| 128 | */ | 
|---|
| 129 |  | 
|---|
| 130 | static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id) | 
|---|
| 131 | { | 
|---|
| 132 | u32 val; | 
|---|
| 133 | u32 next; | 
|---|
| 134 | u32 offset; | 
|---|
| 135 |  | 
|---|
| 136 | offset = start; | 
|---|
| 137 | if (!start || start == XHCI_HCC_PARAMS_OFFSET) { | 
|---|
| 138 | val = readl(addr: base + XHCI_HCC_PARAMS_OFFSET); | 
|---|
| 139 | if (val == ~0) | 
|---|
| 140 | return 0; | 
|---|
| 141 | offset = XHCI_HCC_EXT_CAPS(val) << 2; | 
|---|
| 142 | if (!offset) | 
|---|
| 143 | return 0; | 
|---|
| 144 | } | 
|---|
| 145 | do { | 
|---|
| 146 | val = readl(addr: base + offset); | 
|---|
| 147 | if (val == ~0) | 
|---|
| 148 | return 0; | 
|---|
| 149 | if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id)) | 
|---|
| 150 | return offset; | 
|---|
| 151 |  | 
|---|
| 152 | next = XHCI_EXT_CAPS_NEXT(val); | 
|---|
| 153 | offset += next << 2; | 
|---|
| 154 | } while (next); | 
|---|
| 155 |  | 
|---|
| 156 | return 0; | 
|---|
| 157 | } | 
|---|
| 158 |  | 
|---|